733 590 940
Clamping cylinder after disassembly, Clamping cylinder seals on a tie-bar-less Engel injection moulding machineForeign object: a damaged bolt, Clamping cylinder seals on a tie-bar-less Engel injection moulding machineScoring on the working surface, Clamping cylinder seals on a tie-bar-less Engel injection moulding machineSeal grooves, close-up, Clamping cylinder seals on a tie-bar-less Engel injection moulding machine

Injection moulding machines

Clamping cylinder seals on a tie-bar-less Engel injection moulding machine

A foreign object in the clamping cylinder, found and removed before it caused a serious failure.

Scope of work

Replacement of the clamping cylinder seals on a tie-bar-less Engel injection moulding machine. The clamping cylinder generates the force that keeps the mould closed during injection. When we opened the cylinder, we found an old, deformed bolt inside. This foreign object had been moving around inside the cylinder and scoring its working surfaces. We removed it, cleaned the cylinder, assessed the condition of the surfaces and fitted new seals.

Why it was dangerous

A metal object working under high pressure between the piston and the cylinder deepens the scoring with every cycle and destroys new seals. This leads to internal leakage and a drop in clamping force, which means flash on mouldings and a risk of damaging the mould. In the worst case, the foreign object could have jammed between the piston and the cylinder, risking permanent destruction of the cylinder, a costly overhaul or replacement of the whole assembly and weeks of downtime.

We look for the cause, not just the symptom. Replacing the seals without finding the bolt would have ended with them being destroyed again within a short time.

Having a similar problem with a machine?

Injection moulding machine and industrial robot service in Bydgoszcz and all of Poland. Call us or describe the fault.

Other projects

All